(I have build several aquariums out of both glass and Plexi from 5 gals to 450, and I own 4 sailboats (ok, 3 of them are 11 ft 1 is 30 ft) and do repairs for other owners at the marina as a side job. (again, this is the way most sailboat windows are installed, plexi/lexan to fiberglass hull, some form of sealant, I like Butyl, and then some kind of securing fastener, bolts are better, but I've seen screws) So yes, plastic window to plastic hard top, I would definitely recommend the bolts!!! Anything you put between the two is just sealant, not a trustworthy glue. Now, there are probably many different grades of Butyl, and the stuff I use is probably NOT suited for window installation, so please to some research on your own. You can get it in a tape form at a camper supply (I use it to seal any and all through deck fittings on Sailboats). Butyl is what the industry uses, and it's not that expensive. rear ultra racing strut tower bar-keyhole covers-LT short antenna-JDM black wheel centers-new headlights-Hardtop-new gahh canvas soft top- Save Share. However, even if the rear window was glass I would still not recommend using Silicone, as it's adherence to the composite hard top is questionable. MR2 Spyder Main Forum Best Soft Top Brand. As the title suggests, I wanted to make a quick review of the GrA cf top. Not putting miles on your MR2 is like not having sex with your girl friend so shell be more desirable to her next boy friend. Then the hard top plug will plug in there.if I can remember right. Remove the rear tray and disconnect the factory plug. 6) mark with a white paint pen where to drill/adjust hole. The stock plug has a disconnect under the rear tray. 5) take a look to the gap from the brackets holes and hardtops holes. 4) install fronts brackets with only the 2 bigger bolts from windshield. I only use Silicone to fix plastic to glass if it is not structural. 3) re-installe the hardtop to be sure that he is goodly fitted. BTW, as an aquarium hobbiest/builder while Silicone has tenacious adhering ability to glass, it's "stick" to plastics (plexi/lexan.) is less than 50% of that to glass, and even then it's hit and miss.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |